Smartgen HRC2000 Remote Control

HRC2000 industrial radio remote control used the 32 bit microprocessor technology, Civil wireless spectrum. Achieve a variety of engineering machinery two-way radio control.

HRC2000 industrial radio remote control has two parts: a wireless transmitter (remote control), another is a wireless access the main controller. The transmitter with backlit graphics LCD display (LCD), can show the real-time parameters in Chinese/English and the work and working conditions, such as speed, flow, tap position and other information. Receiving the main controller and the accused of equipment are linked together, power adopt the battery of engine can control equipment the throttle, tap position, etc.

Performance characteristics:

1. The controller uses LCD (132x64) display with the backlight and Chinese interface display.

2. Have remote controller battery capacity display and elv detection function, when battery power weak, the control system will be active close (without any effective output);

3. The remote controller with gravity sensor, there is automatic protection when the remote controller accident fall to avoid the controller button met outside objects of equipment caused by error action;

4. Have a 24 bits address code, ensure that each machine system has the only address.

5. Has two emergency stop signals: one is the emergency stop button on controller, the controller will stop when it can’t get the launch system signal in 0.5 seconds receiving ; When the emergency stop, main control system will be active close (without any effective output);

6. The system frequency use the band 433 MHz civil wireless, the transmit power lower than 10 MW, the transmission distance can be up to 100 meters;

7. Has three speed interfaces: relays, analog and CAN BUS interface, can adapt to the vast majority of the engine speed;

8. The remote controller has start, stop, throttle to add and subtract, tap position.

9. LCD can show the parameters as below: engine speed, tap position, clutch & points, flow, the pump pressure, etc

10. The switching value of the controller is passive relay output;

11. Parameter setting function: can set all the parameter with the controller and then store all the parameter in the FLASH memory storage to lost the data when the power off.

12. The power supply range is (8 ~ 35) VDC of the main control system, can adapt different environment starting battery voltage;

13. Modular structure design, ABS shell, with the inserted terminals, compact structure, convenient installation.